The designed depth is about 0.2 mm which is in the range suitable for the teeth plate
and we do not encourage to adjust the teeth plate too deep which might look nice but
would damage the teeth plate easily, but if you apply the thinner steel coil in production
each time different and need to be adjusted which you may refer to " teeth depth adjusting"
Please watch the video link published in youtube for "PET-strapping clip-machine---
how to change the serration teeth plate"
But if you chang steel material thickness , for example from 1.0 mm to 0.8 mm or
vice versa, so it needs to adjust the teeth plate as shown on the video.
If you start to change the teeth plates, please check the videos twice before you
fully understand how to change the teeth plates
Please arrange your tenchnician to do the job for you instead of putting your hand directly to it.
If you want to adjust the teeth plate to deep teeth effect, we suggest that you'd better to
have a test in PET strapping tensile strength and breaking point testing.
It is not to adjust the thickness of the teeth beyond 0.3 mm because the steel plate is only
0.7--0.8 mm so it is not easy to control the thickness of the teeth when it would punch
and make deeper than 0.3 mm teeth that would damage the teeth plates and the whole
machine.
We strongly suggest that at very beginnig or first time you change the teeth plates
please arrange the technician with experience to do the job for you.
If you meet some difficulties please do contact immediately without heistation
Our working hours:
GMT time: from 8๏ผ00 AM to 14:00 PM
PLease send email to us first when you need guidance on the uninstalling and installing
of teeth plate๏ผ
.zjaska@vip.163.com
If you want to talk or discuss with our engineer directly, please try to add our wechat
first, because we must online comminicate through wechat and translation online through
wechat( engineer speaks Chiense only)
Link to the wechat >>>
๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐ ๐
